エンジニアリング計算機
Voltage Coefficient (VCR) Error Calculator
図の読み方。 The top resistor changes value as the voltage across it rises, so the ratio at 20 kV is not the ratio you measured on the bench. The curve is that drift and dR/R is the error the calculator returns.
A thick film resistor is not the same value at 20 kV as on a bench meter. VCR is quoted in ppm per volt; this turns it into the resistance change and the divider error it causes.
入力
結果
- R1 change
- -
- Ratio at 0 V
- -
- Ratio at working V
- -
- 比率エラー
- -
- Output at working V
- -
式
ΔR/R = VCR × V / 1,000,000. Divider ratio = (R1 + R2) / R2; recalculate it with the shifted R1 to get the error.
電卓に含まれていないもの
- TCR。 The resistor also drifts with temperature and the two effects add. A part with −1 ppm/V and 25 ppm/°C can drift more from a 40 °C rise than from full voltage.
- 非線形性。 VCR is not perfectly linear; the quoted figure is typical at rated voltage.
- Self-heating. Current through R1 raises its temperature, which shifts the value again.
パーツの選択
Where the ratio matters, specify VCR explicitly: the planar thick film range is quoted for precision divider use, tolerance from 0.2%. For matched pairs, send the ratio and the voltage.
計算値と税率を送信してください。 技術見積もりを依頼する6時間以内に返信いたします。