エンジニアリング計算機

High Voltage Resistive Divider Calculator

VinR1VoutR20 VVin

図の読み方。 Vin sits across the whole string, R1 on top and R2 to ground, and Vout is taken at the junction. Both resistors carry the same current, so the ratio R2 / (R1 + R2) alone sets Vout.

Enter the input voltage and the two resistor values. The calculator returns the output voltage, the division ratio and the current through the chain — the three numbers that decide whether a divider is practical before tolerance and voltage coefficient are considered.

入力

結果

出力電圧
-
Division ratio
-
Chain current
-
Total dissipation
-
R1 / R2 voltage
-

式

Vout = Vin × R2 / (R1 + R2). The current through the chain is Vin / (R1 + R2), and the total dissipation is Vin² / (R1 + R2). In a high voltage divider, R1 usually carries most of the voltage, so R1 is the resistor that sets the voltage rating of the chain, not R2.

電卓に含まれていないもの

Three effects change the real output voltage and none of them appear above:

Choosing the resistors

For a divider up to 35 kV, the planar thick film range covers 200 Ω to 1 TΩ with tolerance from 0.2%. Above that, or where the chain must dissipate watts, the power bar range goes to 150 kV. The resistor overview maps all three form factors.

Send the calculated values and the accuracy you need: 技術見積もりを依頼する6時間以内に返信いたします。